Sensors on the crane

Cranes with a variety of models, every day all over the world to complete a lot of weightlifting work, but unfortunately accidents often occur in body weight may lead to even tilt turn,overhead bridge crane some accidents are devastating. Investigation of the accident many conclusions drawn, a consensus is that if before the accident near the operator can get some form of warning, most accidents can be avoided.

Typically, you need to install the sensor on the crane payload force of gravity measurements. Force in accordance with the way the load pressure and tension of the points, the measurement is also somewhat different sensors required, installation is also quite different.
If you are under pressure the way, you need to be measured using pressure sensors, then should the pressure sensor mounted on the fixed pulley shaft down. This installation method requires crane structure has space to accommodate a pressure sensor, or we need to change equipment,bridge gantry crane change equipment costs are generally significant.

If it is stretching the way, you need to use force sensor, then should the tension sensor installed in the lower pulley from the equalizer into the rope around the rope and pull sensor chuck fastening, does not allow slippage. This approach does not change the mobile device, but only for the fixed pulley block pulley equilibrium situation.

Tilt sensor module on the application of the crane as in the excavator, are primarily used in the crane lifting arm and chassis leveling system which.

Tilt sensor module in the application of the  gantry crane  lifting arm is mainly because a guarantee of safety considerations when operating, so that safety systems in the event of security warning before the accident could have the effect. To reduce accidents, manufacturers have developed some safety systems: Safety load monitors, these sophisticated real-time monitoring system can change the crane. In order to make this system work is a necessary measure is also critical boom angle (BoomAngle), this role is the maximum range is 90 degrees (+ / -45 degrees). It is used to measure the angle sensor.

At the same time, requires a lot of equipment for the measurement of time, mainly used in testing, maintenance and alarm system. In order to ensure high quality standards, product every part of the production process are strictly monitored, and each timer prior to delivery are 100% functionality and accuracy of detection.